Amana PTH073G25AXXX Manuel d'utilisateur télécharger pdf (Page 19)

19

Specifications and Accessories Catalog

Framing for Accessory Wall Sleeve (WS9XX)



When installed in an opening, the Wall Sleeve must be

horizontally level (side-to-side) and pitched ¼ bubble

to the outside.

(NOTE: To ensure unit’s maximum eiciency,

DO NOT over- or under-pitch.)



1. If Sub-base (PTSB***E) is installed, allow minimum

3¼" height clearance and maximum 5" height

clearance between wall sleeve and floor; allow

minimum 2¾" protrusion from a finished wall.

See Note 4 if using hydronic units.

2. Drain Kit (DK900D) shipped separately. Can be

mounted either right side, le side or bottom of

sleeve. If mounted to bottom of sleeve, allow

2" height clearance from floor to bottom of sleeve.

3. For UL approval, 265V units must use Amana

®

brand

Sub-base (PTSB***E) or Amana

®

brand Hard Wire

Kit (PSHW04A). Overcurrent protection on 265V units

must be by cartridge-style time delay fuses, which

are included and factory-installed on the Amana

®

brand 265V chassis.

4. If Hydronic Kit (HWK03 or HVK03) is installed,

Wall Sleeve must extend exactly 3" into the room

from the finished interior wall. If using the Amana

®

brand Sub-base (PTSB***E), only the minimum

3¼" height clearance between wall sleeve and floor

is permissible. Unit must also be operated with a

remote-mounted thermostat.

5. If Duct Kit (MDK***) is installed, allow a minimum of

2⅜" into the room from the finished interior wall.

Mounting

Holes

(Drilled by

Installer)

Plastic

Anchor

Screws

Expansion

Anchor Bolt

Toggle Bolt

Wood Screw

Alternative

Fastening Method

(Field Supplied)

Wall Sleeve must extend a minimum of ¼" beyond outside wall to allow for

proper caulking.

FINISHED FLOOR

4

2 1

/

4

"

16 1/4"

MIN

MAIN STUD

JACK STUDS

HEADER - 4" x 4" OR

DOUBLE 2"x 4" ON EDGE

SUB-FLOOR

CRIPPLE

JACK STUD

ADJUST FRAMING TO

SECURE THIS DIMENSION

Wall sleeve opening height should be squared with

wall sleeve opening width.

H = 16¼"

W = 42¼"

1 2 ... 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire