Amana MVH230* Manuel d'utilisateur télécharger pdf (Page 6)

5. Carefully pull out blower unit. Wires extend far

enough to allow blower adjustments.

6. Roll blower unit so blades face towards front of

microwave oven. Wires should be routed in front of

motor frame.

7. Guide wires into duct while placing blower unit back

into opening. Secure blower motor with screw

removed in step 4.

9. Remove 2 screws on front of grille. Remove grille.

10. Install charcoal filter. (Contact dealer to purchase

charcoal filter kit).

11. Replace grille and 2 screws.

12. Proceed to "Preparing Top Cabinet".

C. Preparing Top Cabinet

1. Read instructions on top cabinet template.

2. Tape template underneath top cabinet.

3. Drill holes, following instructions on template.

D. Mounting Bracket Assembly to Wall

Microwave oven needs to be mounted against and

supported by flat, vertical wall. Wall construction should be

minimum of 2 inch x 4 inch wall studding and 3/8 inch or

more, thick drywall or plaster/lath. Microwave oven must

be attached to minimum of one 2 inch x 4 inch wall stud.

8. Replace blower plate using 5 screws.

Caution

To avoid product failure, do not pull,

stretch, or pinch blower wiring.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Amana MVH230* Manuel d'utilisateur Page 6