Comfort. Quality. Trust.Heating®&Air ConditioningAmana1810 Wilson Parkway • Fayetteville, TN 37334June 2001 (1)Rev. 310308713DescriptionThis kit c
10Manifold Pressure Adjustment Cont’d9. Using an Allen wrench, adjust low stage manifoldregulator to the required pressure (Table 2).10. Reinstall the
11Adjustments, Checks, and TestsSize ModelPropane Input(BTU/hr)GUIA, GUIB, GUIC,GCIA, GCIB, GCIC,GUID,GCD, GDC,GUCA, GCCA,PGB**C, PGD**C41,400GUC, GUD
12Setting GUD/GCD Manifold PressureOnly small variations in gas flow should be made when adjusting the gas valve pressure regulator. For propane gas,
2ContentsGeneral Information ...3O
3WARNINGPERSONAL INJURY HAZARDThis conversion kit must be installed by a qualified agency in accordance with themanufacturer’s instructions and all ap
4Orifice Conversion5. Remove the screws securing the manifold and valveto the burner bracket. Separate gas manifold andvalve from burner bracket.ALL
5Package Gas-Electric Cont’dPILOT ORIFICE REPLACEMENTPACKAGE GAS-ELECTRIC UNITS EQUIPPED WITH PI-LOTThe pilot orifice must be replaced on Packaged Gas
6SINGLE STAGE UNITS ONLYThe gas valve regulator spring must be replaced on all single stage gas furnaces and packaged gas/electric units.Replace the g
7WARNINGPERSONAL INJURY HAZARDAll metal screens must be removed from the heat exchanger tubes when using propane gas.Failure to comply could cause ser
8Condensing & Non-Condensing Furnaces1. Reinstall gas manifold and valve.2. Reconnect wiring (and burner box hose on GUD andGCD furnaces) to gas
9The following adjustments and checks are a required part of this conversion. Adjustments and checks include:• Leak checking orifices• Verifying prop
Commentaires sur ces manuels